deflection test

英 [dɪˈflekʃn test] 美 [dɪˈflekʃn test]

弯沉试验

化学



双语例句

  1. Analysis on Deflection and Intensity of Test Methods about YY 0336-2002 Sterile Vagina Dilator for Single Use
    YY0336-2002《一次性使用无菌阴道扩张器》挠度和强度试验方法的辨析
  2. Application of Inclinometer in Deflection Test for Long-span Bridges
    倾角仪在大跨度桥梁挠度检测中的应用
  3. The temperature value obviously depends upon the conditions of the test and the allowed deflection and for this reason, the test values are only really useful for comparing different polymers.
    其温度值明显取决于试验条件和允许偏差,因此对比较不同的聚合物而言只有试验数据是真正有用的。
  4. The paper introduced the key of three kinds of detection equipment deflection test from its usage performance, attentions, description of collecting data and information.
    通过对3种典型的路面弯沉检测设备的使用性能,弯沉检测中的注意事项,采集数据蕴涵信息的描述,总结了3种检测设备弯沉测试的关键所在。
  5. By the deflection test, the deflection produced by the deformation of joint field can be gained, accordingly, the change in the included angle that the beam axis relative to the pole axis can be gained too.
    通过挠度测试,可以求出因节点域变形导致梁发生转动而产生的挠度值,进而可以得到梁柱夹角发生的改变量。
  6. Laser Measurement Method for Beam Section Deflection in Bridge Static Load Test
    桥梁静载试验中梁截面挠度的激光测试方法
  7. In this paper, a new method to establish p-y ( soil reaction-pile deflection) curve by using measured test pile moment has been presented.
    本文给出了由试桩实测弯矩建立P-y曲线的一种新途径。
  8. The Technology and Analysis of Pavement Deflection Test Equipment Application and Its Correlativity
    路面弯沉检测设备应用技术及其相关性分析
  9. This paper mainly introduces principles, technical feature, data correction and its evaluation of four deflection test technique.
    本文作者详细介绍了4种弯沉测试技术及测试原理、技术特点、弯沉数据的修正及其评定。
  10. This paper gives an account of the method of deflection test of large-span steel roof truss and analyses the test result by using element calculation.
    本文介绍了大跨度钢屋架挠度测试法和测试结果,并用有限元计算对测试结果进行比较和分析。
  11. The Paper mainly introduces three deflection test principles, technical features, its applicable conditions, affecting elements, data arrangement, and its evaluation.
    三种弯沉测试技术及测试原理、技术特点和适用条件;数据处理及其评定。
  12. The deflection analysis and test of steel-concrete castellated composite beams
    蜂窝形组合梁的挠度分析和试验比较
  13. Study on pile-soil interaction under large deflection and its model test
    大变形条件下桩土共同工作及试验研究
  14. The paper discussed the popular technique and equipments for deflection test, analyzed the method and index for pavement structural performance evaluation, presented the modified computational method, set up index conversion model, and recommended the rating standard for corresponding index.
    对我国规范中的路面结构承载能力评价方法和评价指标进行了分析,提出了改进的计算方法;建立了指标值域转换模型,并推荐了相应指标的分级评价标准。
  15. Study On Pavement Deflection Test
    简述路面弯沉的测试
  16. Study of Deflection Measure Method on Bridge Load Test
    桥梁荷载试验挠度测试法研究
  17. Under large deflection, large deflection theoretical curve approaches to test curve, its error value is 17.94%, and the amended result is satisfactory. Under large deflection, the shear stress changes a little, the membrane is balanced by strain.
    大挠度下,大挠度理论曲线最接近试验结果,最大误差为17.94%,经修正后结果令人满意,说明此时剪应力变化较小,膜片主要靠张力平衡外载。
  18. The computational load versus deflection curves agree with the test results.
    计算得到的荷载&挠度曲线基本吻合试验曲线。
  19. A proposal concerning the use of multiple-laser-beam-induced deflection of atomic beam to test photon statistics in resonant fluorescence
    利用多光束偏转原子束验证共振荧光中光子统计规律的建议
  20. Through measuring deflection and strain of test girders under loading, performances of this type of box girder, including bending, torsion and distortion are analyzed.
    通过测试模型梁在静力荷载作用下的挠度和应变,来分析这种箱梁结构的弯曲、扭转和畸变等力学特性。
  21. Practical stiffness of prestressed beam has been a difficulty parameter to determine in calculating residual prestressing of the beam by deflection method. The deflection of measurment directly is needed to test stiffness.
    用挠度法计算预应力梁的残余预应力时,预应力梁的实际刚度是一个难以确定的参数,要测试刚度就必须借助于可直接测量的挠度来推算。
  22. The crack behavior, deflection variation, moment redistribution of test beams and the ultimate loading capacity of continuous beam are investigated deeply.
    并综合了数值模拟结果和试验梁的数据结果进行了对比分析,对试验梁的裂缝行为、挠度变化、弯矩重分布以及连续梁的极限承载力进行了较为深入的研究。
  23. There is a factor which depends on the breaking scale in the formula of angle of deflection of timelike and spacelike test particles in this kind of cold stars. It is a possible observational effect for astrophysics.
    对于这类冷天体的类光和类时测试粒子的偏转角公式存在一个依赖于破缺标度的因子。这是一个可能的天体物理观测效应。
  24. The results of fatigue tests indicated that the loading point deflection of the test specimen in fatigue process experienced three increasing stages. They are rapid growth stage, smooth growth stage and a second rapid growth stage until failure. 3.
    疲劳实验结果表明蜂窝夹芯板四点弯曲疲劳过程中加载点挠度的增长经历了三个阶段,即挠度快速增长阶段、挠度平稳增长过程和再次快速增长直至破坏。
  25. Then the there rectangular section beams and there T-beams are tested respectively under static loading. The reinforced strain, concrete strain and deflection of test beams are analysised under at all levels loading.
    然后分别对3根矩形截面梁和3根T形截面梁进行静载试验,分析了试验梁在各级荷载作用下的钢筋应变、混凝土应变、挠度的变化及裂缝变化。
  26. Data acquisition software program is designed by VB language, and then the beam deflection test is completed to realize the maximum deflection prediction of beam by platform design.
    采用VB语言,编写数据采集软件程序,并搭建试验测试台,对梁结构进行挠度测试,进而实现梁的最大挠度值预估。
  27. Specimen deflection test and specimen extension test have been extensively used to predict growth stresses developed in oxide/ metal composite during oxidation time.
    在氧化过程中,广泛采用挠度测试和拉伸测试来预测氧化物/金属复合物中的生长应力。
  28. In deflection test, a single major surface of the specimen is exposed to oxidation.
    在挠度测试中,试样的单一面暴露于氧化环境。